Garage Doors – How To Fabricate Your Own Steel Doors

After i built my barn to accommodate my Jeep workshop, I used to be not sure what kind of garage entry doors I wanted. At first I considered the standard overhead roll-up garage door. I could have got these included in my steel building kit. Even so, price for these car port doors was higher than I wanted to pay for my barn. overhead garage door austin

We shopped around for some used garage doors, but I never found any that I liked. While i built my house a few years back My spouse and i found a really nice pair of wood garage doorways that had a little rot in the bottom. I was able to make vehicle parts for the doorways out of redwood using my saw and a little creativity.

Nevertheless , for my barn, all the roll up and cost to do business garage doors that My spouse and i found limited the cost to do business space too much. A single of the reasons I actually selected the arch metal building construction as to eliminate rafters so My spouse and i did not want garage area doors getting in the way of all my precious headspace.

In my dad’s shop, we always have to be sure we close the doors before jacking anything up very high as it will hit the garage doors. I do not want to do it again that problem in my shop.

I finally chosen fabricating my own material garage doors. Since I actually had plenty of space outside the barn, My spouse and i chose a garage door design that allows the doors to swing open up to the outside. To limit the stress on the hinges, frames and other brooklyn garage door parts, I covered each garage door opening two separate garage doors. Every 10 by 10 garage area door opening has two 10 by 5 car port doors. Four garage gates total for the two garage door openings.

We started by fabricating a frame for each and every garage door out of one in square tubing. The shape was a 10 by 5 rectangle sized to fit just inside the garage door opening. I actually faced the frame with light gage corrugated material sheeting. The sheeting makes a nice match for the galvanized finish on the rest of the barn.

The garage door frame was welded with each other using but joints at each corner and a diagonal brace going from the bottom of each hinge side up to the opposite corner. The completed garage doors are flexible enough to endure being caught I the wind and many strong enough to provide to safeguard the building.

My spouse and i welded a lock hasp to the joining attributes of the garage doorways so that they are locked to the other person for security. A simple padlock is that is required to seal them up.

I think I put in about $200 on materials for the four garage area doors. These cover two ten by ten availabilities. They are easy to open and close so I don’t need an electric opener that We would have felt was required easily had chosen a roll-up or cost to do business garage door. I had been not able to find even a single used door for that cost in my search.

Overall I actually is very happy with my barn style garage area doors. They keep the rain and vermin away and my tools in at night. They allow quick and easy vehicle access and most significantly don’t take up any inside headspace. And with no tracks or motor, these garage doors have been totally easy to maintain.

Leave a Reply

Your email address will not be published. Required fields are marked *